Edge flashing
New drip edge is tucked under the shingles over the gutter which stops the rot from coming back.
Exterior Services
Fascia Repair Roselle, NJ
A roofer in Roselle can repair or replace rotted fascia boards, reattach sagging gutters and fix the drip edge that keeps water off the wood, and check the rafter tails behind the board while it is off. Dial (908) 620-5317 to talk with a local roofer about the fascia.
The fascia sits right where water leaves the roof, so it is the first trim board to rot when that water goes the wrong way. Clogged or poorly pitched gutters spill over the back, and a roof edge with no drip edge sends water straight down the fascia. Over a few seasons the wood softens, the gutter screws lose their grip and the gutter starts to sag or pull away.
What starts as a soft board can spread well past the trim. Left alone, the rot moves into the rafter ends and the edge of the roof deck, which turns a trim repair into structural work. Metal-wrapped fascia is especially tricky because water can get trapped behind the wrap and rot the wood out of sight.
It helps to know what you are seeing before you call. Write down which sides of the house show peeling paint, gaps or a sagging gutter. It also helps to know the fascia material and whether the gutters are original to the house.
If the problem goes deeper than it first looked, a Roselle roofer may also recommend soffit repair or gutter installation.
Looking for Roselle fascia repair? Call (908) 620-5317 to reach a nearby roofing contractor.
Call nowThe process
What happens during a fascia repair
A fascia repair only lasts if the water that rotted it is redirected.
Check the edge
The visit starts with where the water comes from, usually a missing drip edge, a clogged gutter or a gutter with the wrong slope. Probing along the board shows where the rot starts and stops.
Remove the gutter
To reach the fascia, the gutter over it is removed and the hangers pulled. This is a good time to check the gutter itself for leaks and bad seams.
Inspect behind the board
Soft rafter tails are cut back and sistered with new lumber, and rotted decking at the edge is replaced. This is the step that decides whether the repair lasts.
Install new fascia
The new board is fastened to the rafter tails with corrosion-resistant nails or screws, with tight joints at the corners. Wood is primed on every side, including cut ends, before it goes up.
Close the gap
Drip edge flashing is slid under the shingles and over the gutter back, so water cannot reach the wood. This is the piece that keeps the new fascia dry.
Finish the edge
The gutter is reattached with hangers spaced closely enough to carry water and debris. The board is painted to match if it is wood.
What is included
Common fascia repairs
Gutter reattachment
Sagging gutters are rehung on solid fascia with new hangers so they drain instead of overflowing.
Soft fascia
Rotted sections of fascia are cut out and replaced with new boards and scarfed into the existing board.
Framing repair
Soft framing at the roof edge is reinforced so the new board stays put.
Aluminum wrap
Sound wood fascia can be covered with formed aluminum or vinyl wrap once any rot is gone.
Related service
Fascia Board Replacement Roselle, NJ
When rot runs along most of a wall, or the boards are split and warped end to end, replacing the full run of fascia is the cleaner fix. Replacing the whole run gives the roofer a clear look at every rafter tail and the edge of the roof deck. The choice of material affects upkeep, since wood needs paint while PVC and wrapped boards do not.
For many Roselle homes it makes sense to replace fascia while the gutters are off for replacement anyway. Make sure rotted boards are removed, not covered. Also ask about the size of the new boards, since fascia that is too narrow can leave gaps at the soffit and gutter.
Related service
Fascia Board Repair Roselle, NJ
When rot is confined to short stretches, the damaged part of the board can be cut out and a new piece scarfed in. The new piece is joined with an angled scarf joint so the seam is strong and less likely to open. For a shallow soft spot, an epoxy consolidant and filler can restore the surface without cutting the board.
Patching a fascia board in Roselle without fixing the gutter or drip edge above it just buys a season or two. Common fixes include a resealed gutter joint, a cleared outlet or a new length of drip edge. Once the wood is primed and painted on all sides, a repaired section can last as long as the rest of the board.
Local help
Fascia Repair Near Me
Fascia repair calls in Roselle come from older homes with painted wood trim and newer homes with aluminum-wrapped edges alike. From Roselle out to neighboring towns such as Roselle Park, Linden, Kenilworth and Cranford, older roof edges often need board and rafter tail repair while newer ones more often need drip edge and gutter fixes, so a look along the roof edge each spring and fall helps catch soft spots early.
Searching for fascia repair near me from Roselle or Roselle Park, Linden, Kenilworth and Cranford? Call (908) 620-5317 to talk to a roofer who works in your part of town.
Roofs in this climate
Winters here are long and cold, with snow on the roof for weeks at a time and plenty of nights below freezing. When warm attic air melts the snow, the meltwater runs down and freezes again at the eaves, which is how ice dams form and back water up under the shingles. Coastal storms and heavy spring rain drive water sideways into flashing, valleys and old chimneys. That is why roof repair in Roselle is busiest after a hard winter and before the next one.
Why call
Why not wait
Less damage
Small roof problems caught early usually stay small repairs.
Familiar with local homes
Local roofers see the same roofs and storm damage across Roselle and nearby towns.
Know what happens next
Ask the roofer about the cause, the options and the estimate before work starts.
Fascia Repair FAQ
Can fascia be repaired instead of replaced?
Repair is fine when damage is limited to a few spots and the rafter tails are sound. When rot runs along most of a wall or the boards are split throughout, full replacement makes more sense. Either way, the rafter tails behind the board need to be checked.
Which fascia material lasts longest?
Rot-proof materials such as PVC and composite last longest. Wood is common on older homes and works well when kept painted. No material holds up if water keeps running behind the gutter.
Should I cover rotted fascia with metal?
Wrapping over soft fascia traps moisture and lets the rot continue unseen. The gutter hangers still screw into the wood behind the wrap, so they loosen as the board softens. Fix the wood, then add wrap over it.
What causes fascia boards to rot?
Fascia rots when water runs down the board instead of into the gutter. Overflowing gutters, gutters pitched the wrong way and roof edges without drip edge soak the board repeatedly. Once the paint fails, the wood takes on water quickly.
Why do gutters pull away from the fascia?
The fascia is what gutters are fastened to. As rot sets in, fasteners loosen and the gutter starts to droop under the weight of water and debris. New fascia and new hangers together restore a solid gutter line.
More questions? Call (908) 620-5317
Other services that may help
Soffit Repair
Fixing damaged soffits, blocked soffit vents and gaps where animals get in, so the attic breathes and the overhang stays sealed.
Learn moreGutter Installation
New gutters and downspouts formed to fit the house, with the right size, pitch and outlet placement, with the fascia checked before anything is hung.
Learn moreGutter Repair
Repairs for leaky joints, bad pitch, loose hangers and damaged downspouts, without replacing gutters that still have life in them.
Learn moreRoof Repair
Fixing the shingles, flashing, boots and decking that let a roof down, without replacing a roof that still has life left.
Learn more
Looking for something else?
See all roofing servicesGet fascia repair help in Roselle
Call now for Roselle fascia repair and help in the towns around it.