Soft spot repair
Soft spots are cut out and rebuilt so the roof is solid again.
A roofer in Roselle can repair a mobile home roof by resealing open seams, replacing loose fasteners, sealing vents and the AC curb and recoating the roof so it sheds water again. Call (908) 620-5317 to reach a local roofer for mobile home roof repair.
Leaks on a manufactured home roof tend to follow a predictable pattern. Many older homes have a low slope metal roof fastened over lightweight trusses, while others have a rubber membrane or, on newer homes, a pitched shingle roof. For metal roofs, panel seams, fastener holes and dried sealant at vents and the perimeter edge cause most leaks.
A slow drip can do more harm in a mobile home than in a typical house. The thin materials used in many mobile homes stain, swell and grow mold quickly once they get wet. If a ceiling panel bulges with trapped water, a small hole at the low point lets it drain into a bucket, keeping clear of light fixtures, and power to that area should be shut off at the panel if it is safe to reach.
The framing under a mobile home roof is light, so walking it takes care. Weight should go on the trusses, not between them, which is why roofers often use boards to spread their weight. Never go up when the roof is wet or icy, and check the data plate inside the home, which lists the roof load zone the home was built for.
If the problem goes deeper than it first looked, a Roselle roofer may also recommend roof coating or metal roof repair.
Dealing with this in Roselle, NJ right now? Call (908) 620-5317 to talk to a local roofer.
Call nowThe fix depends on the roof type and how far the water has spread.
Every seam, screw, vent and edge is checked, along with low spots where water sits. Stains on the ceiling inside help narrow down the source.
Missing or loose screws are replaced and panels are secured so the roof stops rumbling. Surface rust is wire brushed and primed.
Panel seams are cleaned and sealed with butyl seam tape or a reinforced seam sealer. Membrane roofs get matching patches and seam repairs instead.
Old caulk is removed from vents, skylights and the AC curb, and they are resealed with a sealant compatible with the roof, or replaced if cracked. The edge rail around the roof is resealed too.
Many repairs finish with a roof coating that seals pinholes, protects the metal from rust and keeps the home cooler. Coatings need dry weather and a clean surface to bond.
Soft spots are cut out and rebuilt so the roof is solid again.
An elastomeric or silicone coating is applied to seal and protect it.
Cracked vent caps are replaced with a sealant that suits the roof.
Seams on metal and rubber roofs are repaired so water stops getting through.
Backed out fasteners are swapped so the roof stops rumbling.
When repairs cannot keep up, a mobile home roof replacement removes the old roofing and installs a new system. Older metal roofs are often fastened directly over the trusses with insulation below, so replacement can include adding a deck, more insulation and a new membrane or metal roof. Rotted trusses are repaired or reinforced before the new roof goes on.
In Roselle, mobile home roof replacement plans begin with the data plate and the condition of the trusses. Ask whether a permit is needed, since manufactured homes can have their own rules. Done right, the new roof should end the cycle of patching.
A mobile home roof over installs a new roof on top of the existing one instead of tearing it off. The most common types are a pitched roof over with trusses and shingles or metal, a flat roof over with insulation board and a single ply membrane, and a metal roof over on furring strips. Most roof overs also add insulation, which helps with comfort and with the noise of rain on metal.
For a Roselle mobile home roof over, the roofer checks the walls and trusses, since the new roof adds weight and catches more wind. A pitched roof over changes the structure, so it often needs a permit and engineering, plus solid anchoring for wind. A good roof over ends the seam and screw leaks that plague old metal roofs.
Mobile and manufactured homes in Roselle range from older single and double wides with metal roofs to newer homes with pitched shingle roofs. Owners in Roselle and neighboring communities such as Roselle Park, Linden, Kenilworth and Cranford often find that a well kept coating is the difference between a dry roof and a leaking one, and storms with strong wind are what loosen fasteners and lift edges.
Searching for mobile home roof repair near me from Roselle or Roselle Park, Linden, Kenilworth and Cranford? Call (908) 620-5317 to talk to a roofer who works in your part of town.
Cold winters bring snow, ice and a long stretch of freezing nights. Heat escaping from the attic melts snow on the upper roof, and the water refreezes at the colder eaves, which is how ice dams form and back water up under the shingles. Coastal storms and heavy spring rain drive water sideways into flashing, valleys and old chimneys. Most homeowners in Roselle, NJ have the roof checked in the fall and again after the snow melts.
Small roof problems caught early usually stay small repairs.
Roofers in Roselle know the roof types and weather wear common in local homes.
Ask the roofer about the cause, the options and the estimate before work starts.
More questions? Call (908) 620-5317
Liquid-applied roof coatings that seal seams, reflect heat and add years to a roof, as an option before a full tear-off.
Learn moreMetal roof repairs that stop leaks at the screws, laps and flashing, without replacing panels that are still sound.
Learn moreEPDM rubber roof repairs done with primer, cover tape and lap sealant made for rubber, so the membrane seals again without a tear-off.
Learn moreStopping water at the pipe boots, flashing, valleys and nail holes where roofs actually leak, so the stain on the ceiling stops growing.
Learn moreLooking for something else?
See all roofing servicesCall (908) 620-5317 for a local roofer in Roselle and nearby towns.